Connecting DEQX premate

Function
#1

@ROSELOA @ROSEHAN

I have a DEQX Premate room and speaker Calibration processor which I can use between pre amplifier and power amplifier.
But I think there also should be a way connecting it directly to RS150B
So one of the output from RS150B goes to the DEQX Premate input and DEQX output goes back to a RS150B input and from there to the XLR balanced outputs.
Can you tell me if this is possible?
I did add picture from Premate backside with its inputs and outputs

Thanks

Rear-panel-PreMate
Rear-panel-PreMate1200×535 45.4 KB

#2

@Bitspeed

RS150B (Source) > PreAmp > DEQA Premate Room > RS150B (Analog or Digital Input) > Power Amp > Speaker (Calibration processor) cannot be used.

  • Playback source can be selected from built-in Streaming or external input.

Thank you

#3

I’m not quit sure.
I did order a 110 ohm AES/EBU XLR cable and a spdif 75 ohm cable
Will receive tomorrow and then will try to connect AES/EBU out from Rose rs150 to the AES/EBU input from DEQX Premate and then the spdif output from DEQX Premate to spdif input from Rose rs150.
Then in settings I will switch Rose rs150 input to spdif.
Then signal should go from rs150 to DEQX room correction unit and then back to rs150 DAC and to rs150 XLR analog out.
Will let you know if it works :slight_smile: