Any suggestions for fixed MV setting for fixed volume output?

[mscelfo]

I prefer to use the volume control on my receiver (yamaha rx 8a), and i’m running hdmi video and using the analog output of the rs250. any suggestions on a fixed mv setting?

[ROSELOA]

Hello,

Check your receiver’s manual and find information about input sensitivity.

Tidal playlists

Hello, I searched Marantz AV8805 Preamp manual and found input sensitivity. Seems like it would be great when you set Pre-out level setting as 200mV ~ 300mV (Unbalanced) [Cap 2021-12-21 12-07-04-126] About the 8bit correction of 32 bit sound, as the discription in ROSE device says, some DACs may generate noise when playing a 32-bit sound source with a high sampling rate. For this case, the lower 8 bits are compensated to reduce the noise. If you have no noise, do not turn on. Software volu…

Tidal playlists

Hello, The input sensitivity of the amplifier is a condition for the amplifier to produce the maximum output. If the level of the source is less than 600mV, the amplifier will not produce the maximum output. Conversely, even if a signal with a level greater than the input sensitivity is input, the amplifier’s amplification level is reduced and there is no problem in use. However, if you put in an input greater than 600mV and raise the volume of the amplifier to the maximum, clipping will…

[mikenice]

I’m using the rs250 analog output to Denon x4500h then pre-out to power amplifier.

My setting is fixed on 2000mV and I actually have no noises or clipping.

If I had set my earlier streamer (pioneer n50ae, n70ae, atoll ms120) to fixed output, level was automaticly set on maximum. I think that’s the normal way.

Best Regards
Mike

[Paul]

Hi
Please tell me the correct order or procedure when using the pre out
I am using a Marantz Amp with rs 250
Set to 200mv
I’m controlling volume using the amp not the rose
What volume setting should the rose be on if any before I use the pre amp setting
Please.

[luxury_scruff]

I don’t use the Rose RS250 to control my volume, I do it via my amp - I put the RS250 to maximum volume

[mikenice]

Same as luxury_scruff.
Not using the rs250 volume, using the amp.
And output level is set on 2200mV (maximum), not I had written before 2000mV.

[Paul]

Thanks for the reply the only reason I’m asking is because when I put the amplifier on and set the volume to the lowest setting it still seems quite loud .
Can I ask a stupid question if the rose volume is turned up to maximum is there a reason for this or does it really matter where it set , being as the amp will control volume.
Many thanks for your reply.

[luxury_scruff]

I don’t know your amp, so I can’t comment. further sorry.

Maybe there is a hi-fi forum that could help with your brand and model of amp - maybe AV forums?; https://www.avforums.com