So keep setting to “Off”?
Setting “off” and trigger IN right ?
Yes, trigger in to the RD160.
Okay i have everything set up perfect then maybe just need time to reset.
Make sure you save the change on the RS130. After that, you might want to unplug both the 130 and 160, and then plug the power back on.
Yeah I think i need to turn off the power conditioner too, just like full system reset
Make sure you plug in to one of the USB 3.0 ports. Also, if your USB cable power light didn’t turn on, you may have a defect item. If you have another streamer, try your USB cable on that one.
Yeah i bought exact same thing you recommended but the power light won’t turn on when plugged in. But when I plug in a light to the USB it works . And when I plus the cable in my power adapter , the light comes on too.
Does your USB power cable light turn on when plugged in ?
I don’t need to reboot my devices. I just plug the cable to the USB 3.0 port, the other side (with the power converter plug) into trigger IN port.
Then set “USB/SSD power activation in standby mode” to OFF
That’s all I did.
BTW, do you set the power sync between RS130 and RA180 ? This will turn ON/OFF the RA180 when RS130 is ON/OFF.
If you haven’t done so, please see this post here:
Lastly, since the RD160 is the last device to be turned ON in this trigger sequence, you can set the “USB DAC Notification” to OFF to avoid popping up of the “RD160 not found” warning message. Of course, the message will disappear when the RD160 is fully ON, even the USB DAC Notification is set to ON.
Does your usb power cable light turn on when it’s plugged in ?
The plugging-in was done while all devices were OFF.
My USB step up cable doesn’t have a light on it.
1 Like
If you have an ammeter, check if the voltage on the output-side of the cable is 12V or not, while plugging in the USB side to the USB3.0 port.
Or better use other USB port for testing, rather than doing it on the RS130, to play safe.
Yeah i have voltage meter and this one behaving very odd flickering on and off . I ordered another 5v to 12v step up cable with a voltage meter. Will report back tomorrow.
1 Like
Does your cable make noise ? I have exact same farsense and it makes clicking noise.
No, I don’t hear any clicking noise from the cable.
I can help answer as I had the same issue. I found out the mono plug had reverse polarity meaning the voltage output was reverse -12v probably manufacturer error. You can either cut it and rewire. Or buy another cable hopefully they wire it correctly
1 Like
Thank you that’s very helpful. Can you advise what brand you purchased and from where ?
Hi Bicycle,
There’s no brandname of the converter plug and here’s the link to the site where I bought the plug from China TaoBao:
https://item.taobao.com/item.htm?from=cart&id=567273348602&pisk=gQvmLS0wYI5baPTLkUWjOJ51Euh8Go61gFeOWOQZaa7WHm1OWQjwWUisctKNSFYRPFfscNQNSFKwM0HKpntfCO7iJvHKkttC7EVNb-oNaiII2i5wlS-CCOuKS7eNGvX6RXXCHGPP4asGbRSw7z5PfaSV7i8Nz_SFvrWNQFolaMsL057V_Y7PfaP4_-5azaSNYPPNQ1ok4asNQNlljS7dbZprr7YYf57NzLjciw-oNRyGLJCV8FQzQ2Jlm9_e0a2aQZIdUmKkDq2B2t9B-MLxU-YHALTl4ekirOTW_FSMzvaOhBLXd_xST8-RnNfFzpz4gMXco6JVNle9x1RkEtpq5WtJqZ5heQhSk1BDoB_CgbgWS3bv7Kfzo4Q993pVZeu8EF1MOhIMox228gSYaWoW4RsrXLP_1sS5qwBdMR3BH-3GA0mu9h1VVGRKq0V_1sS5VSnoqWp1ggsFy&skuId=5175201155764&spm=a1z0d.6639537%2F202410.item.d567273348602.23597484uLhgj7
Not sure if they will ship this item to overseas.
However, you should be able to find similar products on Ali Express, Amazon or eBay.